Results 21 to 30 of 63
Thread: Loose steering
-
06-05-2013, 10:53 AM #21David
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD
-
06-06-2013, 09:47 AM #22
At the end of the steering wheel shaft on the housing you can see and feel the shaft move left or right when you turn the wheel slightly , you can actualy feel it come in and out of contact with the cable gear .i had about 2 inch of slop in the steering
2012 Mobius LSV
05 Outback LS SOLD
-
07-16-2013, 09:37 AM #232008 22SSV Worlds
-
07-16-2013, 09:41 AM #24
Loose steering
David
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD
-
10-07-2013, 05:33 PM #25Senior Member
- Join Date
- Jun 2008
- Location
- NOR-CAL
- Posts
- 178
I also had the sloppy issue......
I think my clamp/block down at the rudder might be sloppy.....But I also found that my wheel had quite a bit of play. I reached under my dash to the bottom of the steering wheel shaft and could feel where it met up with the gearbox. I had a good amount of play before the wheel engaged the gears......I checked around the tilt wheel assembly and found it to be loose. If you pull the black rubber trim piece up from around the back of the wheel you can turn the wheel left or right and there is a set/tightening screw. I tightened that up and it helped. But I noticed some more play yesterday and looked around the clamp block and it seems pretty sloppy. Anyone have any idea how much play should be in that clamp block? I guess the ball joint can wear out?07 LSV usually DUMPED
-
10-08-2013, 08:44 AM #26
-
10-08-2013, 09:41 AM #27
So is mine but I haven't attempted to tighten it because I didn't know if it was supposed to be tight or loose...
2008 LSV 1100s 650IBS Reversible Pumps w\Timers
-
10-08-2013, 09:53 AM #28
Loose steering
The clamp block is at the rear by the rudder??
Sent from my iPhoneDavid
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD
-
10-08-2013, 10:41 AM #29
-
06-30-2014, 01:19 PM #30
Is everybody still dealing with the "sloppy steering" issue? Anybody had success with a fix they tried?
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!