Results 1 to 6 of 6

Hybrid View

  1. #1
    Join Date
    Sep 2017
    Location
    North Carolina
    Posts
    22

    Default

    Quote Originally Posted by RC_Hinojosa View Post
    900 on the left, Enzo on the right....

    Sent from my Note9 using Tapatalk

    So on the boat, how do the lines route/connect to the pump and overflow? Is there a T behind the backplate with dual lines coming out the bottom for fill and then a T to merge the two overflow lines to a single port on the side of the boat?

    heath
    2017 Moomba Craz Surf Edition
    High altitude prop
    1140 lb WakeMakers Universal Fit rear ballast upgrade
    Autowake 2.0 firmware upgrade (20171121 version)
    2013 SeaDoo GTI135SE with ski mode
    1984 SeaRay 210 CC - traded

  2. #2
    Join Date
    Jan 2017
    Location
    Katy, TX
    Posts
    1,678

    Default

    Quote Originally Posted by chezdude View Post
    So on the boat, how do the lines route/connect to the pump and overflow? Is there a T behind the backplate with dual lines coming out the bottom for fill and then a T to merge the two overflow lines to a single port on the side of the boat?

    heath
    This: there a T behind the backplate with dual lines coming out the bottom for fill and then a T to merge the two overflow lines to a single port on the side of the boat.

    Sent from my Note9 using Tapatalk
    2017 Moomba Craz Surf Edition
    Flow 2.0 Surf System w/ AutoWake™
    5,600 Lbs Ballast - Enzos + Lead + Sumo
    Wet Sounds REV10s + REVO12-XXX

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •