We all surf port in my family and crew, after going to bigger bags we have to list slightly to keep the surf tabs 65 and under for the port side so no more transfer while surfing for now , yes running a 2017 , the glitches that happen the most are when after surfing port for awhile, turn the boat off to swap riders , after turning the boat off, I turn the key back to the on position after a minute or less to let the system boot up while rider's are changing, before powering off, everything is left in surf port side, when powering back on the starboard plate comes up and the port plate will go down, but the surfer dude is still showing surf port and auto flow is in surf port, no huge issue as I see it happening and flip the auto flow to middle and back and problem solved for now, that issue happens about 1 out of 5 times same. The most frustrating one is when using auto wake , I got everything set for my daughter to surf, ran the boat till auto wake was achieved, turned it off , got her in water and ready , started surfing , no issues, did 10 minute run she drops the rope and goes for a minute without it , and falls out of wake , her own mistake,we circle around throw the rope and go again , never shutting boat off or changing anything, after going for 5. Minutes or so I'm noticing the wave changing for the worse , we stop and looking at the screen the set point in auto wake changed to the starboard settings, auto flow was still in surf port , just set points changed , so it dropped port bag to 50,% and filled starboard to 100% while starboard plate is still deployed. I definitely get glitches in software , see it all the time in New vehicles. Hope there is enough to go of for some think tank action. Keep up the good work , any manufacturer will have some sort issue with something, it's how they address it is key . Thanks for your involvement Matt, speaks wonders about SC.