Quote Originally Posted by blackyj View Post
I have checked the two vaccuum hoses and they are good. Also the intake looks clean when i open the throttle plate, its just the top of the throttle plate that had the black suit on it. The shrader valve on the driver side fuel rail is where i hooked it to and i did get it to run for about fifteen minutes (still dont know how) but as soon as i got it up to about 20mph it died and wouldnt run but for about 5 seconds at a time before dying. I had the fuel pressure gauge hooked up at this time and this is when it stayed between 58lbs and 60lbs and never dropped under 55lbs even after stalling. Before someone mentions it I have also checked the main ground on the engine block and the ground close to the distributor which are both good.
This really sounds like an Ignition Control Module problem. I really don't know off hand if the engine has one of these. I know on older small blocks this was an issue when the module gets hot its internally shorts and kills the engine. Then it cools off a bit and works again. I chased this issue on my Vette. It looks like this and they are in the distributor or mounted outside. When mounted outside it has a 4 wire plug if i recall, and will be mounted to some kind of heat sink. I had a 92 Z28 with one in the distributor and the contacts where corroded so it would run great when the car sat a while, then once it got hot and began to cool off say at the gas station it would crank with no start.

http://www.ebay.com/itm/like/2314390...lpid=82&chn=ps