Plasti Dip

[mmandley]

I just spent about an hour reading through this entire thread, still haven't found my answer haha. Is there anyone that has tried to plasti dip their stock flat vinyl decals??? Or does anyone think it's possible?

Are you referring to the graphics on the side of the boat?

I have not seen anyone on this forum post anything like that. The way plasti dip work is it covers a section, and then the edges of said section is where it will peel. If you tried to Plasti Dip the side vinyl on your boat you would just end up with a black out line of the vinyl.

If you goal is to cover them up then just remove them. Use a high temp hair dryer, or a heat gun on low with 2-3 ft of distance, heat it and start rolling it off the edges. Lots of threads from people doing this. I even did this on my 08 LSV. We call it going Naked.