Custom sub box mount pics.

[jmvotto]

Joe, did you reuse the factory panel and just box the back side in ?

Yes, and increased it from a 10 to a 12" to accomadate the new exile sub. its the black plastic board , but a coated carpeted or vinyled birch ply would work also.

[Boonejeepin]

I would love dimensions.

[jmvotto]

I would love dimensions.

check post #13

I used the first basic option, except the shop pt the sub on the angled side insted of the flat side liked I asked.
I did not have time to build it myself after i found out the factory sub was pretty lousy in open air. so I "subbed" it out do to time restraints LOL i will measure the eaxct tonight for ya.

[jmvotto]

Measurements are close to my first drawing 20 wide by 17.5 height. 5.5 on the bottom and 9.5 on the top for the wedge. These are all outer diameter measurement .

[Woody929]

Yes, and increased it from a 10 to a 12" to accomadate the new exile sub. its the black plastic board , but a coated carpeted or vinyled birch ply would work also.

Joe,
Did you glue this to your box, or are the screws around the sub holding it in place?

[jmvotto]

Joe,
Did you glue this to your box, or are the screws around the sub holding it in place?

I used the sub screws to hold it in place, worked just fine.

[MichiganMoomba]

Measurements are close to my first drawing 20 wide by 17.5 height. 5.5 on the bottom and 9.5 on the top for the wedge. These are all outer diameter measurement .

Looks perfect for what I'm looking for. Thanks for the measurements. Here comes another project.