Sorry to bring up an old thread but this is the best one I have found about installing the Wakemakers gravity 3 upgrade. I am starting this project and have just a couple questions.

1 - what is everyone doing with the old wiring??? I disconnected it under the dash and used the old wiring harness to pull my new wires through to the gas tank channel. Is it ok to leave power hooked up to the old fuse box and just pull the fuses or has everyone separated out the wiring feeding that fuse box and removed it altogether???

2 - thoughts on mounting the pumps to the engine side of the divider panel. My thought was to attach a short piece of hose to each side of the pump and then use a quick connect (like is used to connect hose to the ballast bags) to connect the hoses together. That way you could simply disconnect them if and when you need to lay that panel down or take it out to access the engine compartment. Doing it this way would make it much easier when it’s necessary to replace an impeller as well