I played around with ballast fill times to make sure my tanks were in fact full when the timers turned the pumps off. I've reset them back to a few seconds longer than factory (6:30 rears and 10:30 bow, vs 6 and 10). I think when I increased the times to fill the drain times also increased. Now that I've set them back to close to factory specs, I think the drain times stayed at the higher settings. Are the fill and drain times supposed to match?
Also, any tips on getting the last of the water out of the tanks before I go for a ski? I can hear them sucking air but if I lift the front of the sac a little more water drains out. Are all drain and fill pumps in the rear of the sac? Should I run at 1500 rpm with the wake plate at 0 to try and get my bow up and drain the last few pounds?