Results 1 to 8 of 8
Thread: LSV locker support screw anchors
Hybrid View
-
04-10-2013, 01:23 PM #1Member
- Join Date
- Apr 2009
- Location
- Raleigh, NC
- Posts
- 62
LSV locker support screw anchors
I'm getting the upholstery on my LSV locker tops and engine cover replaced by a neighbor. I took some of the upholstery off of one of the lockers. I had a problem removing some of the screws that hold the strut support bracket to the aluminum board. The threaded tube thing that the screws anchor into had rusted a bit. I need to replace the threaded tube thing, but I don't know what it is called. From the side, it is T shaped. From the top it is circular with a hole in the middle. Also, it has 3 teeth on the edges of the circle that sink down into the aluminum board when it is tightened. Can someone tell me what to look for?
Thanks05 Mobius LSV - gravity 3 ballast and wake plate
single axle trailer
DIY hot water shower installed
DIY tube inflator installed
-
04-10-2013, 01:32 PM #2
Why not take a minute and shoot a pic of the part and post it up here?
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
04-10-2013, 01:46 PM #3Member
- Join Date
- Apr 2009
- Location
- Raleigh, NC
- Posts
- 62
Unfortunately, I already threw them away.
05 Mobius LSV - gravity 3 ballast and wake plate
single axle trailer
DIY hot water shower installed
DIY tube inflator installed
-
04-10-2013, 01:46 PM #4
-
04-10-2013, 01:57 PM #5
-
04-10-2013, 02:03 PM #6
-
04-10-2013, 02:20 PM #7Member
- Join Date
- Apr 2009
- Location
- Raleigh, NC
- Posts
- 62
-
04-10-2013, 02:41 PM #8