Canbus resistor caps

[HFarr]

Does anyone know where under the helm the canbus termination/resistor is exactly located? Picture by chance? I found this plug and am wondering if mine fell off.

Sent from my SM-S721U using Tapatalk

[Holdmybeer]

Do you have things not working correctly, or faults that came on?

Most times CanBus terminators are built into the device so things like this don't happen.

[Holdmybeer]

Do you have things not working correctly, or faults that came on?

Most times CanBus terminators are built into the device so things like this don't happen.

[HFarr]

All my information; speed, rpm, fuel level, would all go to zero. Autowake, tabs, any surf settings, would all stop working. I could see all the gauges, they would just "gray out" like the options were not available. It would come and go. One of the tests for canbus shorts was to measure the ohms on the systems. When battery is off, the system should show 60 ohms total. Mine is showing 120. That tells me one of the resistors is bad or shorting. It says there should be a 120 ohm resistor at each end of the network. I can find the one at the rear, but not the front. The rear tested good. Now having said that, I had noticed my depth and water temperature were not working at all. Even when the other gauges did come on. I unplugged the Airmar Triducer, and everything else seems to work fine now. I think that was my culprit, as I also read that a bad devise can inteoduce interfereance and cause the whole system not to register. However I am still at a loss to find that resistor under the helm. Attached is a picture of the rear resistor.

Sent from my SM-S721U using Tapatalk

[Holdmybeer]

That makes sense.
The rear resistor is 2 prong which is the expected.

The green one in the front is 4 prong and normally not a resistor connection.