Holdmybeer
Senior Member
Find latest postsMini Statistics
- Join Date
- 01-18-2021
- Last Activity
- Today 10:34 AM
- Avatar
Recent Visitors
- 996scott,
- bcharles24,
- hammrd2024,
- JJ Boost,
- Mxmark4,
- Ncatlin01,
- privyan,
- stitch_99,
- tehnoobshow,
- zsophishulzeo9163
- Tab Content
- Holdmybeer's Activity
- About Me
- Tab Content
-
Older Activity
-
05-16-2025, 09:45 AMUpgrading the channels works. You can also add metal strips down the panels to stiffen them up.19 replies | 16483 view(s)
-
05-16-2025, 09:44 AMYou have an ignition wire broken or loose and/or a bad ground. A test light might need to be used over a meter.21 replies | 1444 view(s)
-
05-13-2025, 07:11 PM5.7 350 is the same motor in 89-94 GM trucks. Distributor and parts should be the same. From the coil wires, follow the harness around the back...21 replies | 1444 view(s)
-
05-13-2025, 05:36 PMAre your gauges for temp and oil pressure working? You will not have spark if coolant and/or oil sensor has failed. It cuts off the ignition. ...21 replies | 1444 view(s)
-
05-12-2025, 08:38 PMCoils are weird and heat affected. Could make sense that it failed after it got warm or shorted randomly. Hopefully this is all it is and you are...21 replies | 1444 view(s)
-
05-12-2025, 08:20 AMBad coolant temp sensor or bad oil pressure sensor will cause this. Even unplugged sensors will cause this. They are in series with the ignition...21 replies | 1444 view(s)
-
05-09-2025, 05:27 PMI pulled some gunk out of mine when I first got it. I think these drive condensate a little running in cold water. The gray could be break in...5 replies | 611 view(s)
-
04-30-2025, 09:38 AMI saw the cockpit camera yesterday of the crash. The safety in that boat is fantastic. The guys didn't panic at all and just sat there the whole...6 replies | 1661 view(s)
-
04-28-2025, 01:03 PMFlow 2 vs flow 3 you would notice if you had flow 2 now. Since you don't, I'm not sure it would matter to you but MJH is correct. My question...5 replies | 781 view(s)
-
04-28-2025, 12:44 PMGo easy with the boat erasers. They are super fine abrasive and can damage the stitching. Marine 31 will eat through that also but it has a...13 replies | 9205 view(s)
About Holdmybeer
Basic Information
About Holdmybeer
- Location:
- Columbus, Ohio
Signature
2015 Moomba Mojo Surf Edition
4,000lbs
Manual Flow
4,000lbs
Manual Flow
Statistics
Total Posts
- Total Posts
- 1,396
- Posts Per Day
- 0.88
General Information
- Last Activity
- Today 10:34 AM
- Join Date
- 01-18-2021
- Referrals
- 0