Results 1 to 5 of 5
Thread: Ballast tubing size
-
08-12-2022, 09:13 AM #1
Junior Member
- Join Date
- Mar 2022
- Location
- FL and PA
- Posts
- 28
Ballast tubing size
Looking to do some work to raising the ballast sensors after replacing my rear bags with the WM upgraded bags. Wondering if the stock tubing size is 1-1/8?
Sorry if this info is out there already, I tried googling and did a few searches on here.‘22 Moomba Max
Wakemakers factory bag upgrade (yes its worth it)
Surf Regular, plate at 65, speed 11.1, pitch: 8.5, roll: -1.5
Still tinkering with everything
-
08-12-2022, 12:40 PM #2
Senior Member
- Join Date
- Oct 2018
- Location
- Hockley, Tx
- Posts
- 1,013
It is 1" tubing.
Originally Posted by TOYMCHN
2019 Makai
Raptor 450 w/ 1.76 Trans
WakeMakers 1350s in the rear & 1K in Lead
-
08-13-2022, 08:23 AM #3
Junior Member
- Join Date
- Mar 2022
- Location
- FL and PA
- Posts
- 28
Thank you sir!
‘22 Moomba Max
Wakemakers factory bag upgrade (yes its worth it)
Surf Regular, plate at 65, speed 11.1, pitch: 8.5, roll: -1.5
Still tinkering with everything
-
08-13-2022, 06:42 PM #4
Senior Member
- Join Date
- Oct 2018
- Location
- Hockley, Tx
- Posts
- 1,013
Ballast tubing size
No problem. Just so you know you will need a heat gun to get the hose on the fittings. So just make sure you have one before you start your project. Originally Posted by TOYMCHN
Sent from my iPhone using Tapatalk2019 Makai
Raptor 450 w/ 1.76 Trans
WakeMakers 1350s in the rear & 1K in Lead
-
08-14-2022, 06:33 PM #5
Junior Member
- Join Date
- Mar 2022
- Location
- FL and PA
- Posts
- 28
I do indeed have a heat gun ready to go. Thanks again
‘22 Moomba Max
Wakemakers factory bag upgrade (yes its worth it)
Surf Regular, plate at 65, speed 11.1, pitch: 8.5, roll: -1.5
Still tinkering with everything
Reply With Quote