2021 Mojo

[sleek98]

Pulled the rear bag and did some measurements. It appears the rear bags are 1,250# each and the front would then be 1,500# to make up the 4,000 total.

Dimensions were 22 high 36 long and 20 wide body and 61 long 20 wide and 9 high on the arm that goes up under the midship subfloor.

You can add approx 9-10” of height if you take out the rear bin and leave a vent hose on the top. I assumed the bag was 24” wide earlier when I was hoping for 350-400# per side. However you are only adding 200-250 per side if maxed out every inch of height. These would run you 1,300 with fittings etc, this doesn’t seem cost effective to me. You would be better off running lead for the 500#

If you wanted to just add a small bag on top of the current bag it would gain you 165-175# each side and to me is not worth the cost of $600.

If you throw another midship bag on top of the floor under the seats you can squeeze an instock 60x20x8 bag in there. However there is a seat support that runs right down the middle of the bag and it is 8.125” off the floor on mine so I would want to put some type of foam or rubber guard on it so it didn’t cut the bag. By doing that you could add 400# on each side for 159 each bag. Or do a custom bag that is that would add 325-350# it would run 260 each bag but you wouldn’t have to worry about the seat support rubbing the bag, or you just don’t fill the 8” bag completely full.

Cost wise I think adding the midship bag is the best route as you can add 750-800# for under $400. You could even plumb it in using the top of the rear bag or there are ports on the front of the arms under the subfloor that you can tie into. Downside is you lose that storage when surfing, I currently have 150# of lead there so I already have lost lost some storage there.

I am a little sad the rear can’t get you 350-400# per side but glad the factory used as much space as they did.

If you instead wanted to do a bag on the floor you could be as cheap as $175 for a bag and pump that would get you the same 800#