Quote Originally Posted by htfit View Post
Those fill times are pretty long. If you remove the back panel in the lockers you will see the pumps and the sensor there.

I remember my sensor being pretty low originally before I moved it higher.

If you have not removed the rear panel before there are 2 screws at the top that are obvious and 2 small black screws at the very bottom.

The panel sits on a little channel that you have to push up before pulling it out.

I would turn the pumps on and make sure both are running and inspect the impeller while you have everything open.

Then make sure the sensor is higher than the top of the bag when full. I just put it at the very top.

Hopefully that makes sense and helps.



Sent from my SM-G960U1 using Tapatalk
Can someone post a picture of this sensor and what is meant by moving it up? How do you "move it up"? Are you cutting some of the tubing and moving it closer to the thru hull fitting and in turn above the larger bag or are you just physically relocating it? I am getting ready to add new rear bags to my Makai and have heard that you have to move the sensors up and since I have never opened the panel up before I am not sure what that means.