Proportions kept but from memory, everything shrank a bit except for the trailing edge - that stayed constant at 16 1/2". So basically, it looks the same but if you were to try to drop a precut pad on it, it's not going to fit.
Here's the best I have of the old wave, which in this picture looked pretty stinking good...
Here's the new deck during testing, no rider unfortunately:
They look very very similar, but I can assure you when you watch the wave form now with the new platform it's very quick and clean and starts curling immediately off the hull. I can replicate the disturbance the old platform made by dragging my foot in the wake just behind the corner of the boat.
2008 OBV
325 EFI with closed cooling
Gravity III with 750's in the rear, 400 stock floor, 750 IBS
Servo valve ballast upgrade
Wetsounds Rev10
JL Amps, WS420BT
2000 Outback LS <-- Sold!!!
310 Carb Direct Drive
800# Rear Locker
750# IBS (should have kept this for the OBV)
Dual Batteries with 2 Bank Charger System
Kenwood Head with Remotes
Too many hours restoring exterior from prior negligence to count!