Results 191 to 197 of 197
Thread: Mojo Surf Ballast Setup
-
03-03-2014, 10:16 PM #191
-
03-11-2014, 08:41 PM #192Senior Member
- Join Date
- Aug 2013
- Location
- Richmond, VA
- Posts
- 159
Mojo Surf Ballast Setup
I just installed my 1100s with the check valves in the rear compartments but I didn't buy any additional ballast piping so I can only reach the rear vent on the bag and not the front. Is it necessary to reach the front vent location?
Rusty
2013 Mojo
-
03-11-2014, 08:42 PM #193
Nope, you should be ok.
-
06-20-2015, 11:38 PM #194Senior Member
- Join Date
- Aug 2013
- Location
- Richmond, VA
- Posts
- 159
Mojo Surf Ballast Setup
Has anyone put a T in the center tank to IBS line in order to put a fill/drain on both legs of the IBS?
I just struggle to see how all the water on the opposite side of the IBS is going to drain to the one leg.Rusty
2013 Mojo
-
06-21-2015, 08:26 AM #195
Mojo Surf Ballast Setup
You can try, but it will require you to drill a hole in the floor of that compartment. There are dozens of us that have done it off 1 leg without issue.
-
06-21-2015, 09:38 AM #196Senior Member
- Join Date
- Aug 2013
- Location
- Richmond, VA
- Posts
- 159
Mojo Surf Ballast Setup
What did you ever decide about the check valve and the hard tank situation?
Rusty
2013 Mojo
-
06-21-2015, 10:01 AM #197
Mojo Surf Ballast Setup
Once the IBS was fully drained, I would give the "AIR" fitting on the top center to relieve any vacuum pressure & finish draining the hard tank.