screw lengths?

[motosno963]

I think you should screw through the hull and use through bolts with thread locker. No one else is doing it and you will be unique.

Use stainless screws.

huuhhh..not. a. bad. ideeaaa.. lol

[wolfeman131]

the amp racks are already made, so what would the cutting board be used for

you don't need it if you have the racks made. simply glue something to the hull (pressure treated wood or hpde blocks) and screw your amp rack to that.

[rdlangston13]

I think you should screw through the hull and use through bolts with thread locker. No one else is doing it and you will be unique.

Use stainless screws.

just make sure the screw head is on the outside and the nut is on the inside. for looks....

[maxpower220]

just make sure the screw head is on the outside and the nut is on the inside. for looks....

That's just crazy, you look at the amp on the inside, the head on the inside. Nut on the outside.



You are likely to get some bad advice on forums. Think it over before starting any project.

[motosno963]

caan i rivit everything in? lol

[moombahighrider]

Sure, just make sure those rivets are stainless. You don't want anything to rust. That would suck...

[jstenger]

Also make sure that the center of the rivet doesn't pull all the way through. You will have a little hole to deal with.

Sent from my Droid Charge using Tapatalk 2

[jstenger]

Kidding aside, here is a link to the Supra forum showing the glued block method.

http://www.supraboats.com/bbs/showth...?5519-Amp-Rack

Sent from my Droid Charge using Tapatalk 2

[motosno963]

will look into it