![Moomba on Facebook Moomba on Facebook](/assets/images/chicklet_facebook.gif)
![Moomba on Twitter Moomba on Twitter](/assets/images/chicklet_twitters.gif)
![Moomba on Vimeo Moomba on Vimeo](/assets/images/chicklet_vimeo.gif)
![Moomba on Instagram Moomba on Instagram](/assets/images/chicklet_instagram.gif)
![Moomba on Blogger Moomba on Blogger](/assets/images/chicklet_blogger.gif)
Just thinking out loud after reading Dazes lsv mod thread regarding rear hatch size.
My 1100 surf bag pops the hatch, any reason I cant vent the bag from the rear of the bag instead of on top.? I have the reversible pumps with one way check valves on the vents! May save me two inches on top of the bag.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
Where is the vent on the rear of the bag? Top or bottom. A top side vent will burp the air out more effectively.
2018 Max with a little extra weight here and there
What kind of check-valve is in the vent? Some require a little bit of pressure to open. This allows the bag to bilge a little.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
It's a wake makers check valve.
http://www.wakemakers.com/marine-check-valve.html
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
If the vent line is on the top, then take the check-valve out temporarily. This will allow the sac to vent more freely. It will not raisin on its self during draining like it does with the c/v in place, but it should still have a fairly complete drain with the impeller pump.
Without the cv, the bags dont suck flat , with the cv it's like the space age vacuum bags.
I guess I have to get the timer right so it won't pop the hatch, I prefer the suck flat bags in the rear.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
My 2011 does that too Joe, annoying. Did you add the check valves? I think I might have to do that. Do you just cut the hose and put them inline, close to the bag or the exterior port?
2011 Mobius LSV
Ron
Ron,
Simple install. I cut the vent lines a few inches from the thru hull in a spot where it would be close to, and held out of the way, by a zip tie. Cut the line, slip on 2 hose clamps on each hose end, twist the hose ends on the check valve and position & tighten the clamps.
Enjoy a beverage, or two.
Sent from my iPad using Tapatalk HD