Results 1 to 10 of 26
Thread: G3 timer adjustment
-
01-04-2012, 12:34 PM #1
G3 timer adjustment
Not sure if this was ever put back up when the smeckle deleted all his posts. I had a copy so hopefully this works for others
-
01-04-2012, 12:36 PM #2
-
04-13-2012, 02:15 PM #3
Thanks for putting this up. Changing the timer time is easy now, but I've got a few questions. If on a factory GIII all the bags are 400lbs, why is the front timer set to 3 mins? Should it not be set to 4.5 mins like the back? Also, I just upgraded to 750's in the rear, what should I set the timers to to fill them on a factory pumps?
2010 MOOMBA LSV
340 CAT
ACME 1235
3100#'s
-
04-13-2012, 02:44 PM #4
Good question Krak. I also just upgraded to 750's and will have to adjust
Sent from my iPhone using TapatalkJason
Go Hard or Go Home.......it's MOOMBA time!!
2009 Moomba Mobius LSV
-
04-13-2012, 10:05 PM #5
Wouldnt you just fill the new bag. 3 minutes then. Hit the fill switch again and count the time until it over flows out the thru hull. NOw got back and adjust the timers..
Let me know on the 750 as well..I would guess 8 minutes.Last edited by jmvotto; 04-13-2012 at 10:12 PM.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
04-13-2012, 11:14 PM #6
I filled the new bags up, or close to, tonight with two hits of the switch. Let it sit for about two minutes before flipping to fill the second time. I'll have to get around to just resetting soon I suppose
Jason
Go Hard or Go Home.......it's MOOMBA time!!
2009 Moomba Mobius LSV
-
05-03-2012, 01:38 PM #7
I tried these instructions several times and couldn't get it to go into program mode. So since boat was dropped off at the dealer I'm having them do this...
Sent from my iPhone using TapatalkSOLD! 2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
Tow Rig:
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...
-
05-03-2012, 01:46 PM #8
-
05-03-2012, 02:12 PM #9
I found that my boat has a breaker by the batteries and then one in the engine bay labeled ballast. I tripped both of them in different combinations and tried it and could never get the pumps to stop turning on and be in program mode. It's probably something simple I missed.
Does the 2010 have the reversible pumps like my 2011?
*Side note*...I need to get some vent lines plumbed in this summer. I guess that's three more holes...
Sent from my iPhone using TapatalkSOLD! 2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
Tow Rig:
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...
-
05-03-2012, 02:24 PM #10