Results 81 to 90 of 100
-
09-06-2011, 12:17 PM #81Senior Member
- Join Date
- Apr 2010
- Location
- saskatchewan, canada
- Posts
- 334
well no point in posting pictures......... my platform broke off just the same as the brackets in the earlier posts. They are at the welders right now getting fixed. poor design by moomba, why are the brackets not made out of stainless steel, then you would have no problems.
Did we get an answer on how to tighten the bracket attached to the boat?? I could not figure it out! Again bad design!!!2017 Helix
Wakemakers 1050s
Bow bag ( Surf edition)
Autowake
-
09-06-2011, 12:35 PM #82Senior Member
- Join Date
- Aug 2008
- Location
- Cottage Grove, MN
- Posts
- 780
did the bracket on the transom break, or the bracket on the platform? Also, are you saying that when tightening the bottom bolts on the transom brackets that you can't get them to tighten? The top bolts should be accessible from inside the boat, you might have to pull the carpet back from the wall of the transom.
2006 Outback V - Gone
2008 LSV - Gone
2013 other brand
-
09-06-2011, 12:41 PM #83Senior Member
- Join Date
- Apr 2010
- Location
- saskatchewan, canada
- Posts
- 334
The bracket on the swim platform broke just like in the pictures, when i took it off I noticed the boat bracket was a little loose so I tried to tighten it and the screws just turn. I didnt realize that you can get at them from the inside of the boat, I thought they were glassed in.
2017 Helix
Wakemakers 1050s
Bow bag ( Surf edition)
Autowake
-
09-06-2011, 01:32 PM #84Senior Member
- Join Date
- Aug 2008
- Location
- Cottage Grove, MN
- Posts
- 780
-
09-06-2011, 01:37 PM #85Senior Member
- Join Date
- Apr 2010
- Location
- saskatchewan, canada
- Posts
- 334
Do they just have a nut on them? I sure hope I can get at them!
Anybody out there have a 05 lsv and had to tighten the bolts on the swim platform boat bracket???2017 Helix
Wakemakers 1050s
Bow bag ( Surf edition)
Autowake
-
09-06-2011, 02:02 PM #86Senior Member
- Join Date
- Aug 2008
- Location
- Cottage Grove, MN
- Posts
- 780
-
09-01-2015, 08:20 AM #87Member
- Join Date
- Jun 2008
- Location
- Northern Indiana
- Posts
- 54
Ian,
What LED light do you have? And what has been your experience with it?
Thnaks2011 LSV
Loaded, 340 HP
-
09-02-2015, 10:33 PM #88
How To: Eliminate Your Swim Platform Rattle / Slop...
Wow, old thread!
That boat has 3 VisionX, they were not bad, I think about $200/piece. I sold that boat 3 years ago to my dad, and he hasn't had any issues with the lights.2013 Outback V
-
09-02-2015, 10:35 PM #89
How To: Eliminate Your Swim Platform Rattle / Slop...
Edit: in that video just 1 of the VisionX. I later added 2 more. For what they cost now I'm sure there are better options, but in 2011 they were great bang for the buck.
2013 Outback V
-
09-03-2015, 02:44 AM #90
I'd should have a look at what they are going for now.
PWI as usual...