Quote Originally Posted by cab13367 View Post
Please note that I used a stainless lock washer (see pic below) NOT a flat washer to eliminate the slop. I inserted the washer between the platform bracket and the piece that the bracket slides into that is attached to the transom. I inserted this at the top of where the two meet, which is where the gap is. Inserted the washer with the cut in the 12 o'clock position (on top) and only about 1/2 of the diameter of the washer went in. Make sure you find a washer that is just slightly smaller in thickness than the gap so that it does not slide all the way in. I just got lucky and happened to have one that was the correct thickness. This way, it takes up the gap yet is easy to remove at the end of the day. The gap on the other side was smaller and I did not have a cut washer for it so I left it as is but even with just one washer in place, 95% of the slop was eliminated.

Do NOT drop a flat washer in there as you may have a really hard time getting the platform off!

Al



great post Al .......but would it not be better to insert the cut at 10 or 2 or even 3 or 9 as if it slips down there is no way to compress the cut and possibly make it very difficult to remove the platform. Love the simplicity ,just thinking of a possible woopsie