Quote Originally Posted by saskyrider View Post
well. got things all in under the cubby and everything sounded like crap.... WTF!!! anyways i realised my batts were both just about dead. so pulled them and charged them up. Now everything is good to go. Going to install the tower speakers tonight and had to do some cutting of wires up top on the tower. MAN the previous owner must have been in a real hurry when he did the wiring... no crimping no soldering not a connector to be found... just peel back about an inch of covering and twist like hell... then wrap a crap load of electricians tape around it. oh well made for an easy disconnect.

I do have a couple of problems tho.

First... there are 2 accesory switches on my dash, one is a 2 position switch and the other is a 3 position. The 2 position was the one previously used to switch on my amps and then the stereo switch turned on the headunit... when i hook the wiring back up the way it was with the old stuff the light on the 2 position accessory switch stays on all the time... the amps don't power up until i flip the switch but i can't get the light to go out????


Geoff
If I were to bet, you could take the two sets of wires on the two-position switch and flip them. The switch wiorks fine, but the power is going through the switch backwards, so that the power is coming into the switch on the side the light is connected to. Reverse it and I bet the light will turn on and off with the switch.

It is a guess, but waht you describe could be caused by having the wires backwards, as I describe.

Phil
Kicker