Hi guys,

I was trying to look at the shaft alignement when I noticed that my transission is sitting on the fiberglass hump where the shaft comes in and that my oilpan drain plug is only 1/8 of an inch from the bottom. Also, the four nuts on the shafy flange are completely loose. I don’t think that this is normal. I have added a couple of pictures.
IMG_6809.jpg
IMG_6811.jpg

I think that i should use the four engine mounts to elevate the engine, but before i do that, i would really apreciate any advise. I was able to find a video for a direct drive shaft alignement but nothing for a v-drive. Any help would be greatly apreciated. Thanks