Results 1 to 10 of 109
Thread: Homemade surf tabs
Threaded View
-
09-09-2018, 09:01 PM #11
Thanks! I'm out of town at work for a week, get back Wednesday. I did get the edges of the plates smoothed out, as well as the lower actuator mounts.
I had to rethink those a bit from the original design, because they're made from 2" aluminum square tube, 1/8" wall. With one side removed, they squeeze down on the end of the actuator a bit, and I wanted to remove that little bit of binding. So I left that little strip at the top to eliminate the flex.
When I get home, I'll pull the boat out and swap out the tabs, and give them a shot.2019 Supra SL450