Results 1 to 1 of 1
Thread: Strut bearing
Threaded View
-
05-03-2007, 08:25 PM #1
Strut bearing
Hi
I had problems with my starting motor and the boat hit a rock at a very low speed but bend a little the propeller, and when I was taking off the propeller I realiced that the brass bearing that goes insede the strut was out, someone had that kind of problem, should I just re install it? I check the opresor and it was loose so maybe it just go out, but I will like to know more about this, I dont have a dealer or any one with inboar experience near so any advise will be geat.
Thanks
Similar Threads
-
wheel bearing leaking
By moombadaze in forum Service & RepairReplies: 13Last Post: 04-30-2008, 12:02 AM -
bent strut
By mmoody in forum Service & RepairReplies: 2Last Post: 04-26-2004, 06:26 PM -
strut alignment
By mmoody in forum Service & RepairReplies: 2Last Post: 04-21-2004, 11:43 PM -
Trailer bearing and hubs
By tn_viper in forum General ChatReplies: 0Last Post: 09-09-2003, 07:39 PM -
Drive shaft Strut bearing
By Yellowmobius in forum General ChatReplies: 5Last Post: 09-08-2003, 07:16 AM