13 LSV Ballast Problem

[jpetty3023]

Wolfey just likes spending your money


sent from my ipad2 via a wireless network which usually sucks

[wolfeman131]

Funny, you didn't suggest this at all during the numerous conversations we had regarding my ballast project...sup wit dat?!



Sent from my iPhone using Tapatalk

Since you were whining like a little girl 2 weekends in a row about how hard it was to put in what you did, I didn't want to suggest more work which, ultimately, would have led to me having to listen to more whining.

[jmvotto]

Also, in 2012, SC used used a ¾ inch vent and a 1 inch fill line. As you fill your bags to/over capacity, you're pushing more volume in the bag than can be pushed out. I'd suggest that folks swap out to all 1 in lines - fill & vent.

Is this why my 1100 pops the hatch on the 2012 xlv? I have one way valves on my 3/4 vent lines.

[rdlangston13]

Since you were whining like a little girl 2 weekends in a row about how hard it was to put in what you did, I didn't want to suggest more work which, ultimately, would have led to me having to listen to more whining.

and it shouldnt make that much of a difference, just means your flow velocity in the 3/4 inch hose will be greater than that in the 1" inch hose. , may pressurize the bags some but that should not be bad since people stack them and sit on them while full

[moombadaze]

i set my timers to run 1 minute for every 100lbs with a xtra 30 seconds to make sure i get a little water venting and lets the pump run a little xtra when emptying. so far so good, no issues.

now the one time I forgot to hook the bag up is another story, was very hard to get it back to 0% when there was nothing to drain and the system said i was 60% full.

[kaneboats]

Since you were whining like a little girl 2 weekends in a row about how hard it was to put in what you did, I didn't want to suggest more work which, ultimately, would have led to me having to listen to more whining.

Can't argue with that logic.