




Hello all,
I will be installing the Wakemakers this weekend at my cottage. I found a post a little while ago of somebody that relocated the ballast switches to the same panel the key is on. I cannot for the life of me find this post. I would really like to move the switches as the factory location is terrible! If anybody knows of this post can you please let me know.
Thank you.
Is this what you're looking for? I relocated mine next to the throttle and it was so much better than down low.
https://forum.moomba.com/showthread....llast-Switches
Scott
2021 Craz
2007 Mobius LSV
1997 Sea Ray 190
Not the thread I found earlier. But this does have a ton of good info. Thank you. My plan was to move the switch plate over to the dash next to the key. I know I'll have to relocate the 12V plug.
I did see another thread where somebody moved the switch up close to the throttle and complained people kept hitting the switches with their elbows while driving.
I did a switch plate move on my previous 2007 Supra years ago when I did the Wakemakers upgrade. It was originally located below the throttle lever and I moved it to the area above the throttle. Replaced the wires, switches, fuses, bus bar, etc. I also put some switches for the new LEDS - floor, cup holders, speaker rings.
I do not recall one about moving to the key-area, but it's probably out there.
2018 Supra SL400
I'm still searching for the thread.