Page 6 of 6 FirstFirst ... 456
Results 51 to 52 of 52
  1. #51
    Join Date
    Oct 2010
    Posts
    14

    Default

    Holdmybeer,

    The boats are wired the same as you suggest, I prob. just didn't do a great job explaining it .

    I was hoping I could make the change at the panel to move the radio from switched power to constant maintaining the stock harness setup, but I'm not sure where the switching happens, etc. It's likely far easier to just to wire direct at this point, likely better for noise as well.
    2022 Moomba Makai
    Raptor 400

  2. #52
    Join Date
    Jan 2021
    Location
    Columbus, Ohio
    Posts
    1,288

    Default

    If you crawl under the dash the factory harness is just a couple of white connectors.

    The Fusion radio harness is wired to 1 of those. Follow the red and yellow wires directly from the back of the radio until they join together. Most likely this happens where it meets the white connector skiers installs. Mine did. From there you can modify the harness to the way you want it.

    If you just don't want to hurt a brand new boat (I get that), the connectors can be purchased online and you can wire a new harness and just unplug the factory unit and plug your new one in. The harnesses I'm referring to has the speaker wires and power wires separated in different connectors.

    If you ever want it to be "factory" again just plug the harnesses back together and remove the 1 you installed and you didn't cut any factory wires.
    2015 Moomba Mojo Surf Edition
    4,000lbs
    Manual Flow

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •