EQ Install Advice

[jmvotto]

Wade, on the obv I put two l brackets on the steering column bolts then added some lock washers an nutsthen screwed some plastics board a tad bigger than the eq to the brackets. Then just mounted the eq to the board flush to the board. Its only place I could find to mount on the obv, not enough dash board anywhere else.

Check out my profile pics.

Joe

[muehlcj]

Wade - I ran into a similar problem this spring. I followed JM's instructions as indicated above. Worked great. All you need is a couple L brackets from Lowes, nuts, washers, and a "board" cut so size. I thought I would have some starboard left over from my amp rack but unf. I didn't. I went to Target and picked up one of these and cut to size: http://www.target.com/p/superboard-p...4x17/-/A-85899
IMG00005-20120506-2017.jpg

[Dubwake21]

I mounted mine below the throttle by the gravity III switches. With a trim piece from a stereo place, it looks pretty clean and its at your finger tips for volume control.

[loudsubz]

I just ended up doing my krypt eq this past weekend.

Did what was suggested above. Cut a piece of 1/2 inch plywood just slightly wider than eq, bolted it below the oem switch panel on right side with 2 L brackets, mounted eq to board and also attached a piece of wire to the board near the rear to stop any movement up and down on big waves etc, it's solid.

[jmvotto]

here is the pic

[brain_rinse]

[mmandley]

Tried to PM you, says your full mang =(

[loudsubz]

that looks good! on our 2010 i dont think i have the room under the switches to do that though

[Canuckle Head]

here is the pic

Thanks JM, that's exactly what I was looking for!

Need to climb back under there to see how the L-brackets would attach. How long are these L-brackets anyway?

Cheers!

Wade

[bbuhtz]

Here is what I used.

Here is how I attached it. Both sides.


And here it is finished. Easy, cheap and no fabricating.