Results 1 to 10 of 28
Thread: MAX Ballast ?
-
01-29-2019, 07:13 PM #1Junior Member
- Join Date
- Aug 2018
- Posts
- 16
MAX Ballast ?
I have an 18 MAX with the G6 ballast. The WakeMAKERS upgrade is 1K $$ is there a way to buy a smaller bag and plumb and stack it on top of the factory bag? Is it acceptable to do that?
Any suggestions?
Thanks in advance
-
01-29-2019, 08:34 PM #2
Save up and go the correct route.
-
01-29-2019, 08:59 PM #3
MAX Ballast ?
If you put a ballast bag on top of another bag, it will push the water out of the bag underneath due to its weight, unless you use the overflow of the bottom bag to feed the upper bag.
But this solution is ghetto and could cause the upper bag to roll off and crash the engine diver panels and seriously fuck up your engine.
Do it right. You spent $80+k on a boat, don’t skimp out on $1k and cost yourself another $5k in repairing damage.
Buy once, cry once!
Sent from my iPhone using Tapatalk2017 Moomba Craz
-
01-29-2019, 09:43 PM #4
-
01-29-2019, 10:26 PM #5Senior Member
- Join Date
- Jun 2016
- Posts
- 288
-
01-29-2019, 11:18 PM #6
anybody have pictures of the new wake makers bags installed...or just in general? Im curious to see what they did to get over the hump. Just presuming a couple of connections that go through the hump?
2018 Max - Ultrablue flake/Gray - 4400 lbs water (720s midship), 750 lbs lead somewhere
-
01-29-2019, 11:48 PM #7
-
01-30-2019, 12:47 AM #8
-
01-30-2019, 04:02 AM #9
I can’t figure out why the 2018 exact fit bags are $999.99 and the 2019 exact fit bags are $1,499.99. Both show to be 1800 lbs...
Sent from my iPhone using Tapatalk
-
01-30-2019, 08:19 AM #10Junior Member
- Join Date
- Apr 2018
- Location
- Houston, Tx
- Posts
- 11