Results 1 to 6 of 6
Thread: Outback V Tower Bolt at Base
-
08-04-2014, 05:52 PM #1Junior Member
- Join Date
- Aug 2014
- Posts
- 2
Outback V Tower Bolt at Base
Hello, all. First post. 2014 Moomba Outback V purchased in June. I love it. I noticed my bolt on the Star side was poking about half way out toward the boat. It has a cross screw pattern. I tried to screw it in but it won't budge. Banged with a hammer....no movement. Any suggestions? Dealer not handy. Thanks for your help.
-
08-05-2014, 12:17 AM #2Banned
- Join Date
- Feb 2014
- Location
- My Moomba Lives in Eagle River, WI - We Live in Chicago
- Posts
- 225
It's funny reading this, because I noticed exactly the same thing yesterday on my '14 LSV (we picked it up brand new in May). I've already got 32 hours on it, but I noticed the same thing which made me wonder if it supposed to be that way or if this has somehow managed to slowly come loose over these first hours on the boat. Mine is also on the starboard side, but I haven't tried to tighten it since I am not sure if it's supposed to be sticking out 1/4 of an inch or flush with the tower base...... for what it's worth, the cable that supports the EZ lift Oz tower has snapped or otherwise become detached and doesn't work. Might these 2 issues be linked...?
-
08-05-2014, 08:24 AM #3Junior Member
- Join Date
- Aug 2014
- Posts
- 2
The bolt on the other side is flush with the tower so I'm assuming it's not supposed to be sticking out. I'm not sure what cable you are referring to... I am going to try to lower the tower this weekend and take a look underneath. I have not lowered the tower yet...hopefully not a hassle.
-
08-05-2014, 08:48 AM #4
cke66edy,
The bolt should be flush with tower. Get some assistance and loosen the tower lowering knob to take some pressure off the bolt on the front of the tower base and try to screw it in some more.
North Woods Mobius,
I have only seen the EZ lift on the port side. Might want to check to see if the spring has popped off the mount point. The cable on the starboard side is the stop cable for lowering the tower.
-
08-05-2014, 07:37 PM #5Senior Member
- Join Date
- Oct 2013
- Posts
- 135
on my 13 my tower wiggled and made noise until i tightened those right up and when there tight they don't sit flush i think the right one pokes into the boat and the left one pokes out towards the water or the other way around can't remember but I'm pretty sure when there tight the end of the bolt will stick out 1/2 inch or its not fully threaded also.
2013 outbackv
-
08-05-2014, 08:09 PM #6