Wake makers wave control

[icemanftr]

4K. Lol I just paid $1000 shipped for Manual flow and will use the other 3k for bags, bling, boards, and beer. 😁


Sent from my iPhone using Tapatalk

[jmvotto]

If that would fit my boat I would have gone that route

[spencerwm]

We have sold a couple units to Moomba owners. I can't wait to see the results. With that said it is winter so results may not be available until the spring. Here is a little video of an Outback direct drive with the system installed.

[mikenehrkorn]

Wow!!! How much ballast is that boat running?

[brain_rinse]

I'm watching this product very closely. I'm not a buyer at $4k though...

[jmvotto]

a lot cheaper that a new boat but my 50 ghetto gate works well... wonder how this works on an xlv ??

[spencerwm]

Wow!!! How much ballast is that boat running?

Enough. HAHA. I think it was a couple 750's but they were on either side of the motor compartment.

I'm watching this product very closely. I'm not a buyer at $4k though...

Totally. For those that cannot justify the price there is always a DIY surf gate system or the Ronix Eight.3 Wakesurf Shaper.

[jmvotto]

spencer , what does the key control, just side to side or the angle of the plates?

[mikenehrkorn]

We have sold a couple units to Moomba owners.

Any of those sales for the Outback V? Would LOVE to see what that setup could do for my OBV...

[viking]

$4K is alot of money but cheaper than a new boat. I liked that video of the outback. I think that's the real market for these systems is the DD or the non-surf specific hull. With these installed you can at least get a surfable wake and turn that one trick pony into a multi-sport boat!!

Of course eventually the novelty will wear off and a new boat will be inevitably work its way onto the priority list. But that too will fade away with forum induced mods and eventually lead to another new boat on the radar, with mods to follow, and the viscous cycle will repeat itself again, and again, and again......