need some help!

[outbackv]

ya ill post some pics as soon as i get home! installing them is not as easy as it sounds and yes it is the same system as the factory just you have to bend the actuators to fit the plate not much only about 15 degrees but they are very difficult to bend!!! im pretty much an expert now on bennett trim tabs after all this

btw the guys at bennett are awesome very helpful!

reason for replacing is the whole set up is the hinge holding the plate got a tiny offset bend in it as well as the plate and do to the way the bend is it is you can just hammer it out and i dont

so id like to replce the whole plate set up and was just wondering if anyone has used lenco tabs and just getting ideas of other manufacturers and what not

thanks the the replys

[cab13367]

I think the wakeplates on Moombas are now electric. Thought I read that somewhere.

[mmandley]

I think the wakeplates on Moombas are now electric. Thought I read that somewhere.

Nope don't think so sir. If you open the engine hatch on our boats and on your lower right hand is a plastic cover, kinda smoke colored, that's the hydraulic for the wake plate.

[brain_rinse]

Moomba switched to an electric wakeplate in 2009.

[jmvotto]

ditto on the Electric. ED g was talking about that extensively when Martha was Born..

[wolfeman131]

if I remember correctly, they are now electric & a single actuator

[outbackv]

ill have to look into that and see....