my 08 LSV mods

[mmandley]

hey how hard was it to get to the hoses for this upgrade? what size are the hull fittings?
looks so much better with stainless instead the ugly black ones i think it'd look sharp on my my red boat

You want to order 3/4 threw hull fittings.

To get to the 3 rear ones when you open your rear V storage doors, theres a carpeted backing attached to the what would be the rear seat. Remove the 2 screws and that panel comes off and tou can reach the back fittings.

There is a large bolt that holds the the hull fitting onto the boat. My new ones didnt come with O rings. I got 4 O rings at the local Ace hardware. Make sure they are pretty thick as this is going to be touching the gell coat and you dont want your stainless on your gell coat.

The front one is a bit harder to get to, craw under the drivers dash and you will see the hose connection to the threw hull fitting.

I did all 4 of mine in about 45 minutes.

https://forum.moomba.com/showthread.php?t=7844&page=5