Results 1 to 7 of 7
-
07-07-2009, 01:13 PM #1
Question regarding Filling Ballast III bags
Perhaps a simple clarification...
I have a 2009 LSV that came with the Ballast III system. The manual states that the ballast pumps are supposed to shut off after so many minutes of fill operation. The maual also warns to not overfill the bags, however my understanding is thats what the vent is for - to prevent over filling. I am a little confused, how do you all fill your bags? Do you fill until you have water comming out of the vent holes? or do you constatnly monitor each bag and manually shut the pumps off when they appear full?
Also how full should the bags be? Should they be quite firm to the touch with no rinkles? Does the bag expand when filling?
I am asking the question becuase lately filling/emptying the bags have ended up being a 3 person job, 1 person at each bag closely watching, feeling and reporting its status. I dont think it should be that dificult2009 Moomba Mobius LSV Liquid Force. Indmar 340HP CAT
-
07-07-2009, 01:19 PM #2
I don't have '09, but I fill rear til they overflow..
Brad
2011 Launch 21V Sold... boatless replaced with a Jeep JKUR
2006 Moomba Mobius LSV sold
2004 Outback sold
-
07-07-2009, 04:17 PM #3
Gotta love the ballast on these boats!!!!!!!!1
I just check for the over flow and once water begins to creep out I shut off the flow. This will fill the bag completely and it will be very firm to the touch. Then I empty out the bag for a couple seconds to bring down the pressure. Except for the ski locker, I monitor that one, because when mine is full it pushes up the locker cover.
Good luck!
-
07-07-2009, 04:20 PM #4
-
07-07-2009, 04:41 PM #5
I'm the same....just hit the fill switch and wait till water starts coming out the overflow. That's what its there for as far as I'm concerned. Just make sure there's nothing in the lockers while your filling...never seen one blow up or pop...but don't think I would want to either!!
2006 Mobius XLV
-
07-09-2009, 12:46 PM #6
Thanks guys... So from the sounds of it, you guys dont leave the rear ballast compatments open during the fill.?. I am trying to simplify the process as much as possible so it doesnt appear to be a whole production when you have guest on the boat.
2009 Moomba Mobius LSV Liquid Force. Indmar 340HP CAT
-
07-09-2009, 08:27 PM #7Sled491 Guest
What's the worst that can happen?