Quote Originally Posted by Mxmark4 View Post
Right after I cleaned the entire boat I decided that would be a perfect time to punch a huge hole.in it for a trash can. Grabbed a hole saw and went at it.

this is the 3d printed trach chute that Chris prints out. Has a matching threaded nut you screw on from the back. This one has a flap on it as well which is nice so it's not just an open hole.

installed in the boat and trash can slid inplace under it.
Ole Ron was version 1.0 from Chris. He had to measure everything out after I punched the hole. Had a flap but took it off, was too cumbersome for the kids and little hands. Straight through was easier. The pass through is so nice!