Quote Originally Posted by BrentC5Z View Post
You selling these or???


Sent from my iPhone using Tapatalk
no, just sharing ideas. i figure anyone who can 3d print can make something close to the same since it is a simple design.

Quote Originally Posted by larry_arizona View Post
How does this ease install? I typically just lube and twist into the pump housing, no zip tie required.


Sent from my iPhone using Tapatalk
compared to your method, not much of a time saver since you are going thru the same motions, just eliminates the risk of cutting a fin on the edge of the housing, which i assume is a risk or the factory wouldnt have done the zip tie method.