Quote Originally Posted by Dukabor View Post
Continued due to 5 pictures per post

BA7581A4-1E8F-48B5-A198-15AF2CE3EC76.jpg

D61D9DBA-7A36-43F5-983B-36E6F5B6FAA9.jpg

Have enough material to add a second per panel, plus some 1” 1/8 flat stock to utilize if required as well….

Was $24 bucks for enough material to make 6 angle iron brackets and 6 flat stock braces…. Surprised metal was still that cheap

I know everyone has done this a few times, and knows the issues…. I did notice on the front and back panels they had a small screw in the lower c channel holding them in place, but did not stop the front from popping out at the top after the middle had already pushed into the engine….
I put 2 screws in each of my bottom panels as an added safety as well as the upgraded steel c Chanel. I think I cut mine at 28" as well.

Sent from my SM-G781V using Tapatalk