Results 91 to 99 of 99
-
08-18-2017, 12:29 AM #91
-
08-18-2017, 10:17 AM #92
I put out old spare 400s under the cabin seats so we can fill them when we need a little more weight with a small crew
Sent from my iPhone using TapatalkDavid
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD
-
09-23-2018, 10:51 PM #93Junior Member
- Join Date
- Nov 2016
- Posts
- 6
2018 Update for those taking a look- I added the 1100s in the back lockers, plummed in 450 sumo sacs under the side benches (it took me a couple orders from wakemakers to get the right goodies). Plenty of room under the helm and we wrap jackets around the tower to let them dry anyway (besides, it just looks cool). Now with just my wife and 10 year old I have a great wave. It does take the stock pumps some time to fill/drain (10 minutes or more), but worth it. Total cost was bags/fittings/hoses < $1,000.
Don’t wait- add the weight!
Now I’d like to have Moomba come up with trays for the back lockers!?!?
-
11-08-2018, 09:38 PM #94Junior Member
- Join Date
- Apr 2018
- Posts
- 3
Has anyone tried modifying the tabs themselves? The amount of sideways push Malibu or nautique seams to be a lot more as the moomba’s tabs don’t really go down into the water that far. Seam to affect roll more than sideways kick.
The tabs have small screwed on runners maybe increasing the size of those? Also here is the tray I made.
866D3AB9-E1EA-46E3-8FED-6160E4D67FED.jpg
C87FFC14-DE83-4902-AFA3-29F34168FCAD.jpgLast edited by Huyck22; 11-08-2018 at 09:41 PM.
Schuyler
2017 Mojo Surf Edition
Raptor 400
Red/Silver
Surf Pipe / Wet Sounds Tower
-
11-08-2018, 10:44 PM #95
Check this thread out.
https://forum.moomba.com/showthread....made-surf-tabs
-
08-13-2021, 02:33 PM #96Junior Member
- Join Date
- Aug 2021
- Posts
- 9
Hi. My front ballast on my mojo surf is not filling. I am new to my boat, so I am assuming that this front sack is the only center ballast in the boat. I am trying to figure out why it is not filling even though both rear locker sacks are filling. the switches are lighting up and there is no water leaking into the boat.
-
08-13-2021, 03:08 PM #97
-
08-13-2021, 03:14 PM #98Senior Member
- Join Date
- Oct 2016
- Location
- Tims Ford Lake TN
- Posts
- 453
2016 Mojo Surf Setup with Upgraded Rear Ballast
What sonic said. It’s behind the starboard rear locker carpet panel if I remember correct. If not there then the port side. The front runs longer than rears so it can wear out sooner. Even if the impeller looks good it may not be pumping. Need the Green Jabsco to replace.
2016 Mojo Surf
Raptor 400
1100 rear bags / 500 IBS / 600 LeadWake
Exile amps/tower - Kicker in-boat
FAE
-
08-13-2021, 07:27 PM #99
Also that front bag under the bow fills up from the overflow of the center tank, so it takes about 6 or so min to fill the center tank under the floor then another 6 min or so to fill the bow bag.
2016 Mojo surf edition
1100lbs rear w/ 475lbs piggyback mid/ center 700lbs/ 500lbs IBS/ 600 lbs lead
ACME 2315