Quote Originally Posted by z28ke View Post
Finished installing my taco marine fender holders:



Did you buy 1/2" or 3/8"?

On the receiver piece (female) for the boat, is the bottom of that solid? If the pin is not attached, it does not have a cover, thus I assume water could enter the receiver piece - where does it go? I was reading where one of these companies made one that would drain into the boat (did not have anything on the bottom). The SC ones have a solid bottom, so the water could not go into the the boat. Nautique looks to have one where they have a piece on that pops up/down, acts like a cover.