Results 1 to 10 of 103
Thread: April 2020 Picture Thread
-
04-08-2020, 09:19 PM #1Senior Member
- Join Date
- Oct 2016
- Location
- Tims Ford Lake TN
- Posts
- 453
April 2020 Picture Thread
Ready for the water!!!
2016 Mojo Surf
Raptor 400
1100 rear bags / 500 IBS / 600 LeadWake
Exile amps/tower - Kicker in-boat
FAE
-
04-08-2020, 09:20 PM #2Senior Member
- Join Date
- Oct 2016
- Location
- Tims Ford Lake TN
- Posts
- 453
2016 Mojo Surf
Raptor 400
1100 rear bags / 500 IBS / 600 LeadWake
Exile amps/tower - Kicker in-boat
FAE
-
04-08-2020, 09:23 PM #3
Got out this week after dropping Finn my boat into our lake this past weekend.
Sent from my iPhone using Tapatalk2017 Moomba Craz
-
04-08-2020, 09:45 PM #4
-
04-08-2020, 10:36 PM #5
57°
Sent from my iPhone using Tapatalk2017 Moomba Craz
-
04-08-2020, 11:19 PM #6
Gorgeous day today out at Lake Houston....air 91° water 81°....butter for days
Sent from my Note9 using Tapatalk2017 Moomba Craz Surf Edition
Flow 2.0 Surf System w/ AutoWake™
5,600 Lbs Ballast - Enzos + Lead + Sumo
Wet Sounds REV10s + REVO12-XXX
-
04-09-2020, 08:04 AM #7
Been doing a little garage boating slowly getting her ready for spring. I own a retail furniture store and had to lay off all 10 of my team members, and even though we are technically closed I’ve been working my butt off doing sales by appointment, responding to online inquiries, customer service emails, receiving/unloading furniture and loading customers by appointment. Hopefully I can have the boat water ready in a couple weeks.
Finished installing my taco marine fender holders:
2018 Murder Max
2008 Outback V-Bought new; sold in 2018
-
04-09-2020, 09:26 AM #8
Was a very nice afternoon especially since it’s going to drop back into the 40s this weekend. We kept our anchor distance which wasn’t as fun but worked. Water was still a little chilly but got a few runs in.
Little social distancing dinner. The restaurant staff got a kick outa it.
Sent from my iPhone using Tapatalk2021 Makai
-
04-09-2020, 09:47 AM #9
Did you buy 1/2" or 3/8"?
On the receiver piece (female) for the boat, is the bottom of that solid? If the pin is not attached, it does not have a cover, thus I assume water could enter the receiver piece - where does it go? I was reading where one of these companies made one that would drain into the boat (did not have anything on the bottom). The SC ones have a solid bottom, so the water could not go into the the boat. Nautique looks to have one where they have a piece on that pops up/down, acts like a cover.2018 Supra SL400
-
04-09-2020, 04:06 PM #10Junior Member
- Join Date
- Mar 2020
- Location
- South Jordan, UT
- Posts
- 8
RC Hinojosa - Looks like you got a case of the Corona... Looking forward to those temps and days on the water.
Last edited by Pile of Parts; 04-09-2020 at 04:11 PM.
2005 LSV G3
Let the upgrades begin!