Quote Originally Posted by Edo88 View Post
Was it a pain to glue down?
No, not at all. All the new pieces have 3M backing...I would cut the backing paper in the middle of a piece and fold like an inch back. Then I would position the piece and tape down one side, pull the backing and repeat for the other side.

The real pain is adhesive removal of the existing non-skid on the rear gunnels, swim platform, walk-through & V-drive hump. We're talking major sweat equity....it's nowhere near as simple as some youtube vids make it out to be. Even with the 3M adhesive remover wheel because that makes a huge mess and will overheat all but the most stout cordless drills.