Made a cheap fluid extractor using a bucket, couple fittings, hose and my shop vac. Works like a champ.

IMG_1337.jpg

Last year there was a 12" sub in a smaller sealed box at the helm down at my feet. Wanted to pick up some space under there and was planning on notching the floor hump to slide it back. Then I ran across this ported box and tested it out. Sounds way better so Im trying to fit it in there now. The first picture is as far back as it would go with the hump. There is plenty of room now. Just need to figure out where it sounds the best, finalize placement, add feet to the box, finish the fiberglass and carpet on the hump removal. Then build false wall and footrest.

IMG_1071.jpgIMG_1072.jpgIMG_1074.jpgIMG_1478.jpg