2016 Craz Tower Wiring

[hawgtitan]

I have a 2016 Craz that came from factory with two Roswell tower speakers. I would like to add two speakers to the tower. There are two more holes on each side with rubber plugs just to the inside of the current speakers. When plugs are pulled out, there are wires connected to them. I am assuming these are available for adding speakers. Can anyone tell me where the other end of these wires are. I am sure I will need to add an amp for the new speakers but I can't find where these are going. Thanks!

[MLA]

Can anyone tell me where the other end of these wires are

I would start by finding the bass of the tower where the speaker wires come through the deck. Very common for the pre-wired tower harness to terminate there and the unused wires are bundled up.

I am sure I will need to add an amp for the new speakers

The OEM installed amp is typically a 2 chnl amp. Thats all that needed to drive a 2nd pair of OEM speakers. Is it going to push them to their potential? Thats debatable, but it will drive them.

[stevemarich]

On a 17 craz the speaker wires come out the port side of the tower , mine had about two feet of slack after it came out of the base of the tower , and were bundled up behind the cabin speakers , the starboard side has some wires that come out as well, but I believe those are for if you added a light bar

[Stazi]

I posted the Craz tower wiring diagram a while back


Sent from my iPhone using Tapatalk

[hawgtitan]

Stazi... Do you know where I could find that post? Also, I'm thinking about adding Wetsounds Rev 8's or Rev 10's to go with the factory Roswells. That's why I thought another amp may be handy. Thanks for all the good info guys!

[Stazi]

https://forum.moomba.com/showthread....644#post302644

The A2 wiring schematic is higher up on that same page of the topic


Sent from my iPhone using Tapatalk

[hawgtitan]

Thank so much! This really helps!


Sent from my iPhone using Tapatalk

[Stazi]

We really need to make a sticky out of those two wiring diagrams


Sent from my iPad using Tapatalk

[MLA]

I'm thinking about adding Wetsounds Rev 8's or Rev 10's to go with the factory Roswells

With a pair of Rev-10 and a solid amp, you will not need those existing speakers. The larger 10" speaker is going to dominate ANYTHING up there next to it. Not worth the battery juice to drive the other speakers.

[hawgtitan]

That is kind of what I was thinking also. Thanks for the information!