Ronix wakesurf maker

[KG's Supra24]

Always bow weight

Sent from my SM-G928V using Tapatalk

[Beejwest]

Can someone link the skateboard ramp? Has anyone used that?

[mikenehrkorn]

http://www.amazon.com/Ten-Eighty-Mic...kateboard+ramp

[mikenehrkorn]

Take a look at post #57...

https://forum.moomba.com/showthread....-pictures-here

[mikenehrkorn]

I just ordered that ramp myself....I think it will be a bit easier to deal with than my hand-built gate was

[jstenger]

I have two of these in the garage. The boys got them for Christmas a couple years ago. I think I might "borrow" one of them and try it out.

[DFTR Josh]

I finally got to see the Wake Shaper first hand and this thing is impressive. Full carbon fiber to keep the weight way down. Velcro strips have been upgraded to 3” wide with no space in the middle. Think it was 2 spacers for hull changes at 1” and 2” or total of 3” stacked. For sure a little pricy but from what I can see it is well worth it. Got to see a video of a Wakesetter using it in action and talked with somebody that took it on a demo. He used it on a gated boat so they could really see the difference. Personal opinion of him was the wake shaper was better than the gate but down side was taking time to set it up rater then just a flip of a switch. It was quite difficult to pull the spacers apart and the Wake Shaper from the hull. So far I'm pretty impressed... Now to use it someday.
Wake Shaper.jpg

[jstenger]

I finally got to see the Wake Shaper first hand and this thing is impressive. Full carbon fiber to keep the weight way down. Velcro strips have been upgraded to 3” wide with no space in the middle. Think it was 2 spacers for hull changes at 1” and 2” or total of 3” stacked. For sure a little pricy but from what I can see it is well worth it. Got to see a video of a Wakesetter using it in action and talked with somebody that took it on a demo. He used it on a gated boat so they could really see the difference. Personal opinion of him was the wake shaper was better than the gate but down side was taking time to set it up rater then just a flip of a switch. It was quite difficult to pull the spacers apart and the Wake Shaper from the hull. So far I'm pretty impressed... Now to use it someday.
Wake Shaper.jpg

What are the dimensions?

[DFTR Josh]

What are the dimensions?

I didn't get any measurements, I will see if I can get some.

[mikenehrkorn]

What are the dimensions?

I found one website that lists the dimensions as 20 x 15 x 10 in

http://seattlewatersports.com/produc...kesurf-shaper/ (under additional information)