The only good thing about cold weather is snowmobiling and boat modifications. So I summerized the sleds and started the mods. First thing was to remove the rear walls and move the pumps.







There is a piece of starboard at the rear of the engine compartment. It is the perfect size for the pumps and the module. I drilled a couple of 4" holes and mounted the pumps to the face as shown. The module is mounted directly behind them on the back side. By mounting everything as shown, I didn't have to extend any wiring or hoses. I actually had to shorten the hoses. If you look closely at the pic, you can see that I added a couple of brackets on the bottom of the starboard. Not sure if they were needed, but better safe than sorry, since the starboard is only held on by three screw on top. I have ran the boat a few times, and the new setup has worked great. Even though the hoses are near the exhaust, they do not get hot.