Results 1 to 10 of 17
-
09-27-2013, 01:44 PM #1
***On water - wake plate issue***
Need a little troubleshooting help. Wake plate won't move. Makes noise when I try to move down, no noise when I try to move up.
I just installed my FAE. During installation I removed the bolt joining the ram to the plate for wrench clearance, but I didn't unplug any electric cables or anything like that. And there is nothing restricting the plate from moving - there is plenty of clearance.
Any thoughts?Current: 2010 LSV
Previous: 2007 Outback
-
09-27-2013, 01:54 PM #2
reservoir empty?
'06 Supra Launch 20SSV-gone but never forgotten
-
09-27-2013, 02:04 PM #3
***On water - wake plate issue***
If I were a reservoir, where would I be?
Current: 2010 LSV
Previous: 2007 Outback
-
09-27-2013, 02:16 PM #4
Check the cylinder. Mine split long ways and i have no clue how. My dealer replaced it under warranty.
Chris H.
2012 Mojo
Wake Life
WS420sq,4 Rev8's,JL Amps,2-TypeR 12's,6-Interior Kicker, Green/White LED
-
09-27-2013, 02:16 PM #5
-
09-27-2013, 02:28 PM #6
I had trouble with mine this summer... Topped it off with ATF fluid and works perfectly...
2008 LSV 1100s 650IBS Reversible Pumps w\Timers
-
09-27-2013, 03:25 PM #7
-
09-27-2013, 03:58 PM #8
Your sig says '10 LSV. If so it is electric ram not hydraulic. Maybe it was going out and you noticed while working on the FAE
-
09-28-2013, 05:07 PM #9
UPDATED: ***On water - wake plate issue***
Could not find a reservoir to fill. Weird thing is it began working once I had the boat listed, but as soon as I emptied the sacs it wouldn't work again. This leads me to believe it is a low fluid issue, but mcdye says I should have an electric ram so fluid wouldn't matter. Now I'm super confused on where to start.
Current: 2010 LSV
Previous: 2007 Outback
-
09-28-2013, 06:40 PM #10