![Moomba on Facebook Moomba on Facebook](/assets/images/chicklet_facebook.gif)
![Moomba on Twitter Moomba on Twitter](/assets/images/chicklet_twitters.gif)
![Moomba on Vimeo Moomba on Vimeo](/assets/images/chicklet_vimeo.gif)
![Moomba on Instagram Moomba on Instagram](/assets/images/chicklet_instagram.gif)
![Moomba on Blogger Moomba on Blogger](/assets/images/chicklet_blogger.gif)
Finally starting on the heater install and have a question on where to install the "hot" hose. I have a sensor on the top where Al installed his so am thinking the location Jester shows in the pics here would make the most sense.
https://forum.moomba.com/showthread.php?9877-Winterization-Procedure-with-pics-by-Al&p=82556#post82556
The problem is that the bolt at that location has a square head and nothing in my tool box fits it. I thought just a 3/8" extension would work but it's a little too big. Ideas? Maybe they did that so guys like me don't remove it?
My '02 factory install was above the starter on the block. That appears where Jester's is located at. It is just a block plug.
My '10 was on the manifold next to the thermostat housing.
Do you happen to have a pic of the 2010 location? I'm good with the dipstick location if I can figure out how to get the plug out.
http://www.instgram.com/jlyons30
2002 Moomba Mobius LSV - Sold
2006 Moomba Mobius LSV - Sold
2017 Moomba Craz - Enzos, Lead
I added 2 garden hose couplers so you can winterize easier. What about the other port on top?
Sent from my Nexus 4 using Tapatalk 2
http://www.instgram.com/jlyons30
2002 Moomba Mobius LSV - Sold
2006 Moomba Mobius LSV - Sold
2017 Moomba Craz - Enzos, Lead
'02 - 1 Connection to the block port above the starter and the other to the water pump.
Dan, I used this splitter that came with the kit and added the t stat there and a shutoff valve.
Post 3. Pic 4 below.
https://forum.moomba.com/showthread....ghlight=Heater
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold