Mojo Surf Ballast Setup

[wolfeman131]

Plug I made by filling a fitting with epoxy.



Plug installed at the end of the 370 fill line. I thought this was a simple solution vs another valve. We keep it in the glovebox for when/if it's needed.



Note the boo-boo on my thumb above! That was the result of NOT being patient and waiting for the hair dryer to heat up the tubing well and instead trying to push, twist and muscle crank it on. Take your time and let the tubing heat up, then have some towels or light gloves on to work the tubing over the fittings.

Starboard side was next and was easiest as all I did was install a check valve on the vent line.