Results 1 to 10 of 22
-
07-09-2012, 08:10 AM #1Senior Member
- Join Date
- Jun 2007
- Posts
- 883
request: photo of back of stock deck on 06 LSV
I am about 180 miles from my boat right now, any chance someone could snap me a photo of the back of the stock deck in a 06 LSV?
2006 Moomba Mobius LSV
Stereo: Kenwood KMR-D562BT
Ballast: 750 Surfside locker, 400 Surfside mid boat, 400 Gravity I, 400 Bow
Surfboards: Inland Surfer Red Woody, Triple X Composite X 58"[/SIZE]
-
07-09-2012, 08:15 AM #2
Snyder,
Have 2 '08 LSV's sitting 100 ft from me I can take a pic of. Will that help? What, specifically, do you want a pic of?
-
07-09-2012, 08:21 AM #3Senior Member
- Join Date
- Jun 2007
- Posts
- 883
if it's the same deck, just the back of the stereo and the wires running from it.
thanks!2006 Moomba Mobius LSV
Stereo: Kenwood KMR-D562BT
Ballast: 750 Surfside locker, 400 Surfside mid boat, 400 Gravity I, 400 Bow
Surfboards: Inland Surfer Red Woody, Triple X Composite X 58"[/SIZE]
-
07-09-2012, 08:36 AM #4
Hmmmmm
Don't know if it's the same. Do you know your model number?
-
07-09-2012, 08:47 AM #5
here is a pic of my keenwood 232 mr that came in my 2007 OBV should be pretty similar
http://www.sonicelectronix.com/pictu...ture_id=112701
here is the keenwood mr225 which i think came in the 2006 models page 26 shows the back
http://www.kenwoodusa.com/UserFiles/.../KDC-MP225.pdfLast edited by jmvotto; 07-09-2012 at 08:54 AM.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
07-09-2012, 08:59 AM #6
Nice, JV!
Let me know if you need more, Spyder.
-
07-09-2012, 09:16 AM #7Senior Member
- Join Date
- Jun 2007
- Posts
- 883
i was just hoping to see it wired up so i know what i'm up against
2006 Moomba Mobius LSV
Stereo: Kenwood KMR-D562BT
Ballast: 750 Surfside locker, 400 Surfside mid boat, 400 Gravity I, 400 Bow
Surfboards: Inland Surfer Red Woody, Triple X Composite X 58"[/SIZE]
-
07-09-2012, 11:41 AM #8
A mess is what your up against! Seriously, the factory is not known for "clean' wiring so if it's never been touched back there it will be hard to decipher anything from a pic, not to mention that a straight on rear pic in an LSV is almost impossible due to space. What exactly are you trying to do?
2007 Mobius LSV
-
07-09-2012, 11:44 AM #9Senior Member
- Join Date
- Jun 2007
- Posts
- 883
well, i have no car audio experience whatsoever.. just trying to figure out if it would just be a straight swap to upgrade to the Kenwood KMR-550U.
like using existing wire harness and existing remote on drivers seat. just simply pulling out the old deck and putting in new one.2006 Moomba Mobius LSV
Stereo: Kenwood KMR-D562BT
Ballast: 750 Surfside locker, 400 Surfside mid boat, 400 Gravity I, 400 Bow
Surfboards: Inland Surfer Red Woody, Triple X Composite X 58"[/SIZE]
-
07-09-2012, 11:58 AM #10
550u rear pic
http://www.sonicelectronix.com/pictu...ture_id=933021
looks like it will plug and play asumming the wiring for power ground and remote lead is the same, but when you compare the plugs the 232 has lots of blanks , so some of the functionaly of the newer unit wont be used unless you re wire the whole interface.Last edited by jmvotto; 07-09-2012 at 12:01 PM.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold